MACHINE: Tentering and stentering machines (RMS 207)
MODEL: K10 D
- 3 overlapping compartments (total 6 compartments) powered by 12 gas burners
- machine is equipped for knitting and therefore also for Shuttle
- machine with two speed ventilation with gate dual position and also the cooling output is double gate position with the lower and superior air control. Adjustable air compartment to compartment with manual gate to have a higher flow rate on the bottom
- Entrance area with two lateral selvage dry infrared + wheel selvage glue inox + cutter outlet with suction selvedges
- steamer in entrance + overhanging suction cope
- each compatments has a economy box to preheat the fresh air inlet with the hot air output
- with a polishing Ferraro 2-cylinder with adjustable air pressure and steam heat to a height of 2.20 meters work.
- working width 2200 mm min 800 mm
- exit by big roll, can produce single rolls controlled cutter or faldare the fabric with a cross lapper
- conical field induction is over 6 meters
- introduction is Erhard-Leimer
- vertical Kolb chain pins with firm tissue to 5 fingers
- Thermoset Mahlo for humidity control and speed control.